Flush the ARP table entries on the PE by doing ‘ clear arp host-name| MAC-ADD’ and.To correct the issue try the following during a maintenance window: If the count for ‘LOCAL_CE_count’ increases then that verifies that traffic is hitting the local PE, but the router is enable to learn the MAC address. In the above configuration under term2, the MAC address is for the remote CE device and the counter REMOTE_CE_count is incremented whenever frames from the remote CE hit the local PE.Īpply this filter under forwarding options inside the routing-instance on the PE show configuration routing-instances VPLS_INSTANCE forwarding-options family vpls Initiate traffic from CE to CE again. To do this, enter the ‘ show interfaces ge-X/Y/Z unit n’ command.Įncapsulation vlan-vpls show configuration firewall family vpls filter vpls Verify if VLAN encapsulations are used on the CE facing interface of the interested PE routers. Note: While these troubleshooting steps can be applied for all code versions and all platforms, this troubleshooting guide is written primarily keeping MX platform in mind.Ĭonfirm you have initiated traffic from CE to remote CE, so that the PEs will learn or attempt to learn the MAC addresses.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |